In the past week, Dragger is suddenly not honoring the set increments in the Studio toolbar. For example, if my set default is 1 degree rotations and 0.1 stud increments, the dragger will rotate and move parts at 45 degrees and 1 stud increments instead of my chosen settings.
In this example, if I want the dragger to move my parts at 0.01 stud increments and rotate at 2 degrees again, I must type in any number other than 0.01 and 2, then type 0.01 and 2 to restore my settings. This is required upon every file open.
Iām on macOS, this issue began happening sometime last week.