Feedback on my baseball bat

Help and Feedback Creations Feedback
1

Hey there, Me again! I did make another blender creation today, a baseball bat! I think it looks great to me, but I am currently just looking for some more feedback on how I could improve the mesh and or texture itself! Thanks, I appreciate all the nice feedback I get!

image

image

7 Likes
2

Looks nice, I personally have played high school baseball and little league. The bat’s top doesn’t really look realistic it should be more rounded. The grip should also be higher. If the bat is wood do not add grip if its metal please do. Also if the bat will be retextured to wooden make sure to make your knob and top more round. Other than that it looks nice. :+1:

3 Likes
3

Nice job! Looks really clean.

I would suggest that you texture the handle grip a little differently though. Most metal bats have a rubber/grippy handpiece, as in this image:

221920351390-0
221920351390-01600×1600 92.8 KB

Normal bats also get thicker towards the end, since this is where you will collide with the ball, and remain thin for a larger portion of the bottom half. You don’t often see a tip ending at a point either, like in your Model. I would recommend either rounding, or flattening it out.

As far as the quality of the Model though, it looks very nice :smile:.

Keep up the great work!

3 Likes
4

It looks really good, the only thing I would change would be to round the top and the bottom edges a little bit more. Great job :grinning:

1 Like
5

I would make it a little more realistic unless you were going for a cartoonish like but it looks really good

2 Likes
6

Thank you for the wonderful suggestions, and thank you for the compliment!

1 Like
7

Aye, thank you very much for those suggestions and the compliment!

1 Like