Is meshing big part models useful?

I need a bit of help, sometimes when I build using either unions or just a lot of parts, I typically export it as a mesh and than import it, my mindset is that itll help the preformance and reduce part count but in realistic terms does this do anything?

2 Likes

It should, I’m not sure as I never tried, but it depends, if before you had 5000 triangles and 100 parts, but then you have 6500 triangles and 1 part it’s probably good, if it’s before 5000 triangles and 10 parts and then 8000 triangles and 1 part probably not m, but I’m not an expert so

You could always use blender to decimate your model slightly to reduce the tri count and optimize it better.