left side
right side
how do i perfectly make the gap from the edge the same on both sides?
2 Likes
What I just do is have a part in the middle and duplicate it then just turn one of them by 180° then drag them locally instead of globally.
1 Like
I would move each column to the edge of the block, then set the move increments to 0.25 or 0.5 and move both of them the same amount of times. I hope this isn’t too confusing, let me know if it is.
1 Like
I’d say this method is easier, A better visual point of how it would work using PivotPoints and Rotation
2 Likes
how did you move the part to the center?
Set the position of the cylinder to the position of the other part.
1 Like
ohhh, thank you ㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤ