Need help with scaling

Hello all, I need some help with a recent problem I’ve been having, what happens is when I want to scale in one direction, the part scales in two directions, this is a problem for me :slight_smile:

1 Like

Try taking a look at this, it has some handy information that could possibly help.

1 Like

That should only happen when you press & hold the “Control” key on your keyboard. Try pressing the key and then scaling, maybe it got stuck. Or try using a different keyboard.

Are you pressing Ctrl? Or something Is interfering with that?

I think I know. This problem also occurred to me, but I fixed it by deselecting “Join Surfaces” on the top. Hope this helps!

1 Like

I’ve seen other people with this issue. It has something to do with the part being welded, and trying to resize while maintaining the weld.

1 Like

I think the “Join Surfaces” is causing the welds, so turning that off should work.

1 Like

This normally happens when you hold down the control key, perhaps there’s something interfering with that key? That’s the only solution I can really think of.

Nope, that’s not it. I switched keyboards, and same problem :frowning:

EDIT : I think it stopped, will post an edit if happens again, thank you for your help everyone!