Hey, so I ran into a problem with my Region3 collision detection system. It works great, however, when my models get rotated by 90 degrees, the region I’m making is still centered in the model, and due to some models not being symmetrical in size, half of their size will stick out of the collision zone. I figured using a rotated region3 module would make this easier. However, I’ve tried a couple and none seem to work. It seems like there’s internal issues with them, assuming I’m utilizing it correctly based on the documentation I read.
I was going to say that a Community Resource exists and that you should search first, but supposedly you already tried some and had no success with them. Incidentally, was this one that you tried?
I figured using a rotated region3 module would make this easier. However, I’ve tried a couple and none seem to work. It seems like there’s internal issues with them, assuming I’m utilizing it correctly based on the documentation I read.