I’m a bit new to building, but how would I go about getting the black-halo-square out of this union.
I’m wanting to get the black part. (simpler: square with a hole in it)
There is a button next to Union and Negate that is called Separate I believe. I’m opening studio right now to look further, give me 2 minutes
Edit: Aha! found this on the documentation before my studio got to load, hope it helped
if i remember you can separete it if script. i think
Hmmm Negate,Separate seem to not work.
???
What does that mean???
!@#!
To do this your way you need to put another Negated Part (Block) where the white area is and Union the black and white Part with the Negated Part.
The easiest way is to just get a black Part (Block) the size of the black section of the Union, and make a Cylinder the size of the hole. Negate the Cylinder, then Union the black Part with the negated Cylinder.
If the Color isn’t right you can use the UsePartColor checkbox.
confusion…???
30CharLimitIsDumb
This is what @Scottifly means:
-
Place the Negated Block around the area you want to remove.
-
Press the Union button and it should end up looking like the picture below.
Thanks, I now got it.
#30char-
How confusing can it be?
Make a square block the size of only the black section of the Union you showed us.
Make a cylinder the size of the hole, longer than the hole so it sticks out both ends, and at the same Position of the square block.
Negate the Cylinder. This will make it transparent red.
Union only the block and the Cylinder together (not the original white and black Union, you can move it out of the way completely).
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.