Went building today on a new aircraft and stumbled upon a issue while trying to use CSG for making the cockpit glass.
I used a normal cylinder mesh part to work with and started by layering them so I could have them join up later as a whole union.
Curved the unions so it resembles the cockpit better that I am trying to make and sliced it in half and took the inside out of the cylinder.
After hours of perfecting it I tried to join the layers up by using CSG, I hit the 2500 triangle mark (which should really be higher…) so I divided them into sections.
Now I am stuck on this annoying transparency strip issue…
this is just 1 section and not the whole canopy that I am making.
I was just testing to see if it would happen, which it did.
Tried at least 4 other ways and came to the same result.
File is here for anyone else to check out.
You can put them together with the move tool set to 1/5 stud grid.