I think the clamps that are holding the wire in place are a little too eye grabbing. What are some ways I can fix it, or am i just going crazy?
5 Likes
It looks great! But the wires kinda look like their going into the roof and not the clamps. I just have one question, is that that one wire plugin that lets you do stuff like this with wires and ropes? Cause if it is could you tell me the name? I have been trying to find that plugin for a while now.
1 Like
You could use rope constraints, it’s much easier y’know? 
I’d just make the clamps a bit smaller, and make them a bit darker.
There are also other versions of ring meshes in the toolbox so you could make a thinner version too.
1 Like
Try having the clamps spaced out more - there seems to be too many to me. Otherwise, I like it a lot.
1 Like
I actually didn’t use a plugin I just got a circle mesh and stretched it to look like wires
1 Like
XAXA made that plugin. It’s called ‘RopeMaster’.
2 Likes
you should use oozledraw. I use it for my obbies, but it has many other uses, too.
The issue I have with oozledraw is that it only supports Block Parts, not Cylinder Parts. I’ve made hanging wires with it before, but had to make each Part a Cylinder, manually rotate it 90 degrees (or select them all and rotate them with the Studio Build Suite plugin) then resize each Part to make it round like a cable would be.