Gapfill... but with curves?

Help and Feedback Building Support
#1

Hello!

Lot of people reccomend gap fill to fill gaps, and I do too! The problem I am facing is that gap fill only does a straight connection between the two selected faces.

I was wondering if there was any plugin just like gapfill that had the option to make fill the gap with a curve?

1 Like
#2

Not that I know of but if you are just looking to make curves try using Archimedes Two (v2.4) - Roblox but if it doesn’t solve your issue maybe try placing small parts at angles and places you want the curve to go, feel free to ask if you need elaboration I am bad at explaining things.

#3

@JustDenzX makes a good point.
Say you have 2 Parts (Part1 and Part2) at 90 degrees to each other (Part1 at 0 degrees and Part2 at 90 degrees), but want to make a curve with 2 sections to it.
If you take a Part the size you want at the halfway point of where you want the curve to be and place it with one side in the middle at 45 degrees then you can use GapFill between Part1 and the ‘center’ Part. If you delete the center Part and then use GapFill between the 1st section you created with GapFill and Part2 you’ll have a 2 section curve.
Use more ‘center’ Parts at different angles to create smoother curves.

Curved Gapfill
Curved Gapfill1359×648 26.7 KB

In this picture the blue left Part2 is 1x6 studs, the right Part1 is 1x4 studs.
The red ‘center’ Part is placed at the center at 45 degrees and is 1x5 studs but is placed with the right side of it at the center where I want the curve to be.
I used Gapfill to create a section between Part1 and the right side of the center Part. I coloured this section green and made it semi-transparent.
I then used Gapfill to create a section between Part2 and the right side of the center Part. I coloured this section yellow and made it semi-transparent.
You could create as many sections as you want by using more center Parts, but I’ve found that the Archimedes Plugin does a better job for creating curves.

1 Like
#4

The only problem with this is because it cant support multiple axes at the same time. (If archimedes could do multiple axes at the same time, all my issues would be completely fixed)

1 Like