I was having a hard time seeing the outline for the PrimaryPart on one of my models and I wanted to increase the Line Thickness setting for it, but it didn’t change anything. There’s also a limit on the Line Thickness for PrimaryPart that doesn’t allow me to get a thickness that makes it more visible.
When selecting a model with a PrimaryPart, the outline that goes around the PrimaryPart is barely visible on certain models. Here’s an up close example:
You can’t even see it in this video due to it being so tiny. All you can see if that the compression around the edge changes. At the beginning of the video, the PrimaryPart is set and then it is set to nothing.
You can set it in your Studio settings. It used to be a stud based line width, but now it’s measured in pixels.
Has it changed recently for you? In Studio for me it’s the same today as it’s been since they released the change months(?) ago.
Turns out the outline was there like normal, but it blends really well with a lot of colors. Not only that, but Line Thickness for the PrimaryPart doesn’t do anything anymore. I’ve updated the bug report to be about that instead.
I think I was just using a default baseplate with the spawn location grouped inside a model and set to the PrimaryPart. I tested it out right now and I’m no longer seeing the problem that was shown in the video, so I’m assuming it has been fixed.
