So I’m working on this house and I want to put these tiles from the already tiled part(It’s one object I joined them) onto this angled piece of roof(the untiled part) but I’m not sure how to do it
I tried putting them on individually but it was taking up loads of time and it didn’t look good anyway
Any suggestions? Thanks for the help.
If you want to cut a piece of roof to tile that section, the best way is going to be to use a boolean modifier on a copy of what you already have. Take the mesh and set it up how you want it, then take a cube and set it up exactly where you want to cut your mesh (imagine it is the blade of a knife) and then put a boolean modifier on the tiles, and select the cube you are using as your cut and then you will end up with two separate pieces after you apply the modifier and it should be shaped how you want it to be… Might take a bit of practice to get it right. Good luck!
