Quick staircase model

Time taken: 20 minutes.


Feedback appreciated.

Portfolio: https://thulicore.artstation.com/
comms still wide open

14 Likes

This is amazing, I’m not good at modeling but when I saw this, I would immiediently move to building than scripting

1 Like

Highly detailed for a quick 20 minutes build, nice. I like the design choice you’ve gone for, it looks like it could fit in almost anywhere while still standing out.

Looks great but I think it would be better if the bars weren’t tilted sideways

2 Likes

its pretty good, the connector pole thingies have the thin and do be thin kind of but not reallly. the poles should be upright because it doesn’t look good like this (the stair is going kind of up and its flat but then this is diagonal. pretty good looking though.

Looks extremely detailed as all builds that come from you are. I thought poles that supported the rails were perpendicular with the floor though?

Also,
image
You can see the cylinders going through each other and aren’t aligned.

Thulicore-quality builds always looking good!

2 Likes

That is honestly an amazing staircase. You are a very talented developer.

Yes the support poles are normally perpendicular (at 90 degrees to) the floor, like this:
image

1 Like

Perpendicular, not parallel, my bad! :tongue:

1 Like

Nice, this would have taken me hours to do XD