So lately the rotating tool for blocks does not work for me while it had worked in the past. I’ve used to see marks or “points” while I was rotating and it wasn’t doing it very fast as the example showed. I’ve tried setting the stud to one and trying to set the degree to 1* but it still wouldn’t work. Any help is appreciated.
Here is an example:
Also, please correct me if this is the wrong category, but I’m not sure where to put this in and I thought this is the category for this kind of stuff.
Maybe it’s because the part is connected. I’d that doesn’t work it’s because it’s on the ground. Furthermore if it’s a model it won’t work unless it’s the entire model itself
Go under Model and enable Rotate:
Setting to 1 degree is almost like not enabling the rotate feature… I would advise changing it between 5 and 15 degrees, and make sure it is check marked.
