VTS 1.4 driver guides
Hello, in this guide you will find how to set up all vehicles currently in V1.4, including all destination systems, and some with fun facts about the vehicle.
General info, controls
Route codes, as of V1.4.0:
–Passenger routes–
21: Vasútállomás, Gedeon utca, Veteránok terét érintve
22: Vasútállomás, Gedeon utca, Városi Fürdőt érintve
8: Vasútállomás, Kertváros, Autóbusz forduló
9: Kertváros, Autóbusz forduló, Vasútállomás
–Misc routes–
500: Garázsmenet (To the depot)
600: Nem szállít utasokat (Not in service)
1111: Műszaki pihenő (on break)
Keybinds
R: Front door
T: Second door
Y: Third door
U: Fourth door
F: Driver door (not on all vehicles)
L: Head lights
K: Interior (passenger area) lights
J: Interior (drivers cab) lights
Z: Left blinkers
X: Hazards
C: Right blinkers
Q: Make pole rope shorter
E: Make pole rope longer
V: Trolley switch
Now onto actual guides
Bus startup
After spawning your vehicle, start it up by pressing the button shown on the image
Then press L to turn on your head lights
After a bit, you will see your destination system starting.
When it started enter one of the route codes (found above)
After you entered it, press ENTR
That is how to start a bus in VTS 1.4
Trolleybus startup
After spawning your vehicle, start it up by pressing the button shown on the images
Ikarus 280T:
Trollino 12:
ZB01:
ZiU 682G and YMZ T1 doesn’t have main switch
After a bit, you will see your destination system starting.
When it started enter one of the route codes (found above)
After you entered it, press ENTR
After entering your route, you will need to put yout poles on the wires.
To do that, you need to exit cab, then go to back of your vehicle, then click the pole or retractor to grab the pole. Put them on the wires.
After that you are done if you have the modern destination system (Digital)
If you have the old destination system, you will have to do the following after starting the vehicle:
Open this door:
Click this destination board:
Then this:
You walk to the back, then open this door:
Then you go back ot the front, put in the dest board, then close that door.
Then you go back to your cab, and do enter your route code, then press ACC.
That is how you set up your tbus if it has old type of destination
–Trolleybus wire switchers–
VTS 1.4 has two different types of switches at the moment (which will get reduced to the newer one, we are just too lazy to replace this one)
Older type switch:
If you want to go left, then you turn your trolley switch off, and if you want to go right, then you turn your trolley switch on.
Newer type switch:
To go left on this, you turn your trolley switch on, if you want to go right then off.
This switch has a visual direction screen near the switcher.
