Do you want to weld a model, but there are so many parts and you are afraid you will miss something?
Good thing there’s an X-Welder plugin!
X-Welder: a plugin that will allow you to weld your model quickly and easily.
Modes of operation
Modes of operation:
Each mode connects only BaseParts and creates WeldConstraints.
Neighbor Mode
Neighbor Mode
This mode is suitable for models created for physics simulation. Each part will be welded to neighboring parts that are very close.
If “Welding at the lower part” mode is enabled, the weld location will be at the bottom, part 0 at the bottom, and part 1 at the top. This has no effect on anything, but it is convenient.
Brick Mode
Brick Mode
Brick mode, like neighbor mode, is also suitable for physics simulations. Each part will be welded to the top part (part rotation is not considered).
Primary Part Mode
Primary Part Mode
(from one part to all parts)
Select a model or multiple models and press start. Each model must have a PrimaryPart.
This mode is suitable for welding all parts to PrimaryPart. All weld instances are in Primary Part.
Weld Remover
Weld Remover
The weld deletion mode deletes: Weld, WeldConstraint, Snap
Weld Teams Viewer
Weld Teams Viewer (check welds)
The weld command view is a very handy feature: you can select a model or a group of parts and easily see if the weld is solid.
Button meanings:
Select - ready to select parts, select parts or models and press the button.
… - the process of defining groups is in progress.
(If there are no welds in the model, the process may take a long time.)
Remove - you can delete the result
Removing… - delete the result in the process
Teams
Teams are arranged in descending order: the largest team at the top, the smallest at the bottom.
If there is only one command: the welding is integral.
If you click on this, the camera will move closer to the middle of the team (works strangely)
The green square changes color depending on the team.
WeldConstraints - number of exactly WeldConstraints
Weld Objects - the number of Weld, WeldConstraints and Snap.
Eye - turn off/on the highlighting of parts in the command
If you have any suggestions or comments: write, I'd be very happy to read them :]
